Our IICRC certified team at Austin Fire & Flood tracked creeping baseboard moisture in a Cedar Park home to standing water under the hallway furnace, then found corroded copper lines behind the bathroom vanity. We handled the whole job, from water damage restoration and structural drying to new floors and a rebuilt hall bathroom.
Here’s how these calls usually start. No burst pipe, no gush of water, just a baseboard that looks darker than it did last month. Plenty of folks would shrug it off. Good thing these homeowners didn’t.
| Job at a Glance | |
|---|---|
| Location | Residential home, Cedar Park, TX |
| What we found | Standing water under the furnace and corroded copper supply lines |
| Areas affected | Hallway, hall bathroom, linen and pantry closets, HVAC closet, one bedroom |
| Drying time | About one week |
How Did We Find Water Nobody Could See?
We found it with a thermal camera, not a sledgehammer. Thermal imaging shows temperature differences, and wet materials usually read cooler than dry ones. A scan at the base of the hallway furnace lit up with moisture, so we opened the return air platform under the unit. Sure enough, there was standing water sitting where nobody would ever look.
Lots of Central Texas homes have this setup. The furnace sits on a hollow platform that doubles as an air return, with drain lines and plumbing close by, so water can sit there for weeks unnoticed.
That’s why we start with thermal imaging and leak detection before we pull anything apart.
Then the Walls Came Open
Once we opened the lower drywall in the hall bathroom, we found a second problem. The copper supply lines behind the vanity were heavily corroded. Two problems in one house happen more than you’d think, so we never stop at the first trouble spot.
Here’s what that first visit turned up.
| | | |
How Far Did the Water Spread Under the Floors?
The water traveled a lot farther than the baseboards let on. It had moved across the concrete slab under the vinyl plank flooring and reached the hallway, hall bathroom, linen and pantry closets, the HVAC closet, and a bedroom next door. Vinyl plank handles spills on top just fine, but it can trap water against the slab underneath.
Slabs are standard around Austin. Concrete acts like a hard sponge, soaking up water slowly and giving it back even slower.
Our guide to the signs of water damage in walls covers the early clues.
A Surprise Behind the Baseboard
When we pulled the trim along one wall, we found what looked like mold at the base of the drywall. We treated it as suspected mold and handled it with care. Guessing isn’t a plan.
The EPA’s guide to mold and moisture says wet materials should be dried within 24 to 48 hours. It also says to keep AC drip pans clean and drain lines flowing, which every Texan with an HVAC closet should hear.
Below is the suspected mold, plus the containment and drying setup that followed.
| | | |
What Does Drying a Slab Home Actually Involve?
Drying a slab home takes containment, careful tear out, and daily moisture checks. Our crew sealed the work area with plastic sheeting, removed wet materials that couldn’t be saved, and ran commercial dehumidifiers and air movers until pin and pinless meters showed the structure was dry. That took about a week from our first visit.
Here’s what had to come out:
- Wet baseboards and door casings
- The lower section of drywall
- Vinyl plank flooring over the wet slab
- The hall bathroom vanity
Containment keeps dust and possible mold spores out of the rest of the house. It also gives the dehumidifiers a smaller space to dry.
We follow the IICRC standards for restoration work, so we measure dryness instead of eyeballing it. Dry isn’t a feeling, it’s a number.
We’ve seen this before. A similar HVAC drain line leak in Georgetown also hid its damage until we opened things up.
What Did the Finished Rebuild Include?
Once the slab was dry, we cleaned it, prepped it, and rebuilt the damaged rooms ourselves. The homeowners got new flooring and trim through the hallway and closets, plus a rebuilt hall bathroom with a new vanity. Because we handle drying and rebuilding under one roof, there was no handoff to a different contractor.
With our in house rebuild and remodeling crew, the folks who dried your home are the ones putting it back together. Nothing gets lost between teams.
The linen closet is our favorite before and after from this job, going from a bare wet slab to clean floors and fresh trim.
| | | |
What Can Cedar Park Homeowners Learn From This Job?
Small signs near the floor are often the first warning of a much bigger leak. Darker baseboards, swollen trim, or a musty smell in the hallway can all point to water you can’t see. In Central Texas, the HVAC closet deserves a regular look, since drain and plumbing problems love to start there.
- Check around your HVAC platform for water or rust a few times a year.
- Watch baseboards and door casings for stains or swelling.
- Don’t trust the floor alone, since vinyl plank can hide a wet slab.
- Call early, because every day gives water more room to travel.
Texas summers push AC systems hard, and our guide shows how AC condensation causes hidden water damage in local homes.
Seeing Water Signs in Your Cedar Park Home?
If something looks off near your floors or HVAC closet, call Austin Fire & Flood. Our IICRC certified crew is on call 24/7, every day of the year. We work directly with your insurance company and handle everything from leak detection to the final rebuild, so you deal with one local team from start to finish.